Commit d0bec92c authored by Juri Linkov's avatar Juri Linkov

Move configuration explicitly to the first step.

parent 91ca6606
2009-01-11 Juri Linkov <juri@jurta.org>
* INSTALL.CVS: Move configuration explicitly to the first step.
2009-01-09 Glenn Morris <rgm@gnu.org> 2009-01-09 Glenn Morris <rgm@gnu.org>
* .dir-locals.el: Don't set indent-tabs-mode. * .dir-locals.el: Don't set indent-tabs-mode.
......
...@@ -5,6 +5,11 @@ See the end of the file for license conditions. ...@@ -5,6 +5,11 @@ See the end of the file for license conditions.
Building and Installing Emacs from CVS Building and Installing Emacs from CVS
If this is the first time you go through it, you'll need to configure
before bootstrapping:
$ ./configure
Some of the files that are included in the Emacs tarball, such as Some of the files that are included in the Emacs tarball, such as
byte-compiled Lisp files, are not stored in the CVS repository. byte-compiled Lisp files, are not stored in the CVS repository.
Therefore, to build from CVS you must run "make bootstrap" Therefore, to build from CVS you must run "make bootstrap"
...@@ -13,9 +18,6 @@ instead of just "make": ...@@ -13,9 +18,6 @@ instead of just "make":
$ cvs update -dP $ cvs update -dP
$ make bootstrap $ make bootstrap
Of course, if this is the first time you go through it, you'll need to do
./configure before the "make bootstrap".
Normally, it is not necessary to use "make bootstrap" after every CVS Normally, it is not necessary to use "make bootstrap" after every CVS
update. "make" should work in 90% of the cases and be much quicker. update. "make" should work in 90% of the cases and be much quicker.
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment